SITE MAP
DON'T MISS THESE:
PRODUCTS
OVERVIEW
Model 105 System
How
the 105 Works
Machine
Specs
Die
Tooling
200
Fixture
Print
Die Systems
Marking
Ink Systems
Example
Applications
Instruction
Video
Satisfaction
Guarantee
Power Stamper
Get Catalog
Affiliate Dealers Welcome
MODEL 200
Offset Imprint Placement Fixture
Accessory
for the Model 105
The JanTech Model 200 fixture enables the user to place offset imprints onto parts with repeatable precision. It is particularly useful for very small imprints and for placing imprints into difficult locations. Imprints can be placed in depressed areas, on uneven surfaces, and even close to obstructions.
The Model 200 fixture is designed for an imprint area of about 1 X 1 1/2 inches (25mm X 38mm) and can accommodate parts up to 2 1/4 inches (57mm) tall.
The Model 200 fixture quickly and easily mounts on a Model 105 machine in place of the standard work table.
The included clamping system enables X-Y adjustment of the fixture under the machine imprint area. The four post transfer table provides the Z and tilt adjustments for printing die contact to the offset pad.
The part being marked is placed in a part holding device (positioning jig) that is secured to the elevating work table. The height of the elevating work table is adjusted for contact of the offset pad to the part. The work table also provides for final small X-Y and rotational adjustments of the part under the offset pad, to fine tune the placement of the mark on the part.
The
Model 200 fixture is shown
mounted to a Model 105 machine,
ready to imprint
the offset pad (red).
After imprinting the offset pad,
the handle rotates the offset pad
to transfer the imprint to the penny
shown positioned on the work table.
